Simple Cart/Atomizer Mod

[ScvWill]

OK so, all of us are always looking for new and more efficient ways to use our cartridges. Usually I just don't even use a cartridge anymore, and just drip and smoke directly from the atomizer. Works perfectly, but I have to drip a lot.

So this little mod I did was with my 510, and what you end up with is a good way to drip without using the cartridges. You just put a blank cart tip on the end.

Step 1. Take a 510 cartridge and remove the filler material, clean it and set it aside.

Step 2. Take either a small paper clip or a staple and straighten it, then bend it in either a V or U shape, just long enough so that the open ends will sit at the bottom of your atomizer, with the bent end of the staple/paperclip just under the rim of the atomizer opening. Apparently I can't put images in here, every site I link them too leaves a broken image on here.

Step 3. Take some of your filler material, a very small amount, and roll it into a tight little ball. Make two of these.

Step 4. Take the two filler balls and secure them to the ends of the bent paperclip/staple.

Step 5. All you need to do is get those two filler balls on either side of the atomizer wick. Now you don't necesarily need the paperclip or staple, but I like to have it on there so that I can pull the balls out.

Step 6. Drip onto the atomizer wick. The liquid will drip down onto the filler balls. The heat from the atomizer comes out of those two sides and it activates the material perfectly. Hope this works for you too.

[Royal]

Apparently I can't put images in here, every site I link them too leaves a broken image on here.

HI ScvWill,
You will be able to post links once you reach Full member status. You will be able to reach this level once you have made a minimal number of posts.
I have turned off links for Junior members in order to help ensure against spammers. This has been done as a precautionary measure.

Welcome to ESF.